How to Install Oil Seals
Oil seals come in a variety of shapes and sizes. They are often referred
to as gaskets, o-rings, packing, or swivel seals and can be made of
such things as rubber, cork, composites, and even leather.nok seal.
Nonetheless, they are all made to do one thing, to ensure that the oil
used by a machine has been sealed inside to keep it from leaking out,
which could otherwise cause mechanical failure. Commercialized types of
oil seals need to be pressed on using hydraulics or specialized tools,
but common do-it-yourself o-rings and gaskets can be installed using the
same basic techniques. Have a question? Get an answer from a handyman
now!How to Install Oil Seals
1.Remove the original oil seal. An o-ring can be pried out with the edge
of a flat-bladed screwdriver, and a gasket can be scraped off with a
drywall knife.
2.Wipe any dirt, debris, and/or leftover oil from the area with your dry
rag. If any sticking particles remain, scrap them off with your
screwdriver or drywall knife.
3.Brush on some pipe dope to the area, which the new seal will cover.cap seal.
4.Place the seal over the pipe dope and press gently over the top to purge any air gaps between the pipe dope and the seal.
5.Brush on some pipe dope over the top of the seal.car seal. Make sure there is a solid and continuous application of pipe dope over the entire face of the seal.
6.Attach the part over the oil seal, lining up any screw or bolt holes,
and tighten it up as per the manufacturer’s directions.How to Install
Oil Seals.
No comments:
Post a Comment