Silicone motorcycle oil seals.When installing a Teflon (trademark) seal after replacing the seal sleeve, you can apply sealant to the outside of the seal casing and press it into the seal housing. Teflon (trademark) seals must be installed using a mandrel type
seal installation tool. This expands the seal lips as hey slide over it and the shaft seal surface.Silicone motorcycle oil seals.
Avoid putting oil on the shaft sleeve or on the Teflon (trademark) seal. These seals simply work better when they are installed dry.
When the compressor is started, a small amount of Teflon (trademark) seal material is deposited on the sleeve to ensure a prefect airtight seal. Be careful not to knick the inner lip of the shaft seal as an irregularity will cause a leak.Silicone motorcycle oil seals.
If you damage a seal during the assembly, it is best to toss it in the trash and start over with a new seal. It is never a good idea to put a compressor back in service with a questionable shaft seal.
Installation Tips, Rubber Lip Seals.If the shaft is round and running true, you can use a Loctite (trademark) sealant between the seal and the seal housing when replacing a rubber lip type shaft seal. Press the seal into the seal housing and lube it up with compressor oil.Silicone motorcycle oil seals.
Oil the shaft and , after installing new seal housing gaskets or o-rings, slide the seal and housing onto the shaft. On shafts with no reduction to the keyed drive area, a dummy key way plug may be required to avoid shaft damage. Be careful to center the seal housing while sliding it on,
ease the seal over the shaft and carefully tighten down the housing bolts in a crossing pattern.Silicone motorcycle oil seals.
No comments:
Post a Comment