Affordable nak oil seals Beautiful in Colors

Affordable nak oil seals Beautiful in Colors.I just redid my left fork seal, and the upper (shiny part) of the left fork, today for the 2nd time since doing both in Achorage early this May, I tried to do it with out taking the entire fork out of the mounts. But it will save you time and knuck skin if you just take the bloody hold thing out. Rememer to re-aline the front axel before putting the tire back on. i tighten the bolts that #4 on preivioius pict. withthe axel in then put the tire back on.
as for replacing the fork seal. by taking the entire lower fork off you will have the ability to remove the bad seal easier. they are really tigith fit. also be very careful on putting the new one back in not ot damage the inner seal ring part of the seal. I used a large socket for to evenly get the seal to sit flat on the metal o-ring that goes below it. I had BMW Anchorage show me how to do it with their BMW speciality tool, I used a large socket that just fit into the lower fork section. If you have a friend with mechanic shop they should have a large enough socket. Affordable nak oil seals Beautiful in Colors.
in addition, i put a bit of extra grease on the top cap to help keep dust getting into the seal and wearing it out quicker. To get old seal out is a pain and you need a L shaped hook type of tool to pull it out. that is why i take the lower section, so i can use my feet and legs to get a good hold on the fork to pull the seal out.Affordable nak oil seals Beautiful in Colors.
thing to check while doing seal replacement
take the tiem to clean out any grime in the bottom of the fork lower section, i use a little but of desiel fuel as a solvent and clean inner part of the fork of and grime fork oil that did not drain out.
the uper part of the fork (shiny part) will slide in easily if the seal is sitting flat on the lower metal o-ring. also take out the tiny hex bolt on the top of the upper part of the fork to let air in as you re-insert the lower part back onto the upper part. and then when everything is at the right place tighten the tiny screw back to seal the fork.
In addition, you should check you upper fork section to see if there are any fine scratches… i had some bad ones from all the dirt roads i ride in Colorado, that could be the reason you seals are wearing out so quickly. And buy a pair of fork covers.Affordable nak oil seals Beautiful in Colors.