Removing a pushrod head
Undo the nuts or screws holding the rocker cover to the top of the head. Carefully lift off the cover.oil seals.
If it sticks, tap the side gently with a soft-faced hammer. Set the cover upside-down on clean newspaper to catch oil drips.
Overhead-cam engines often have a distributor mounted on the head, which need not be removed. But remove it if in doubt, and re-time the ignition afterwards.dust seal.
You may need to loosen the rocker-shaft support pedestal nuts or bolts gradually in sequence, then remove them. Lift off the rocker shaft and put it on clean newspaper.
On engines with separately mounted rocker arms, take off the nuts holding the arms and the pivot balls, then remove the arms and set them all in a row on a piece of paper numbered with their correct order, so you can refit them in the same places.oil seals..
Lift out the pushrods and stick them through numbered holes in a piece of cardboard or plastic foam; they too must go back in the same places. Keep them in a clean place.
Use a socket and bar to loosen the nuts or bolts securing the head in the reverse of the tightening sequence for the engine (see car handbook). Some engines need a special adaptor tool to fit the bolts. cap seal.
Carefully lift off the head, complete with manifolds if possible. You may need a helper to lift the head. If it sticks, tap the side gently with a soft-faced hammer.
Set the head right way up on wood blocks to protect its machined undersurface. Remove and discard the head gasket, after checking that the replacement one is the same in every detail.
Take care not to let any dirt or carbon particles fall into the engine while you are working on it.oil seals..
Undo the nuts or screws holding the rocker cover to the top of the head. Carefully lift off the cover.oil seals.
If it sticks, tap the side gently with a soft-faced hammer. Set the cover upside-down on clean newspaper to catch oil drips.
Overhead-cam engines often have a distributor mounted on the head, which need not be removed. But remove it if in doubt, and re-time the ignition afterwards.dust seal.
You may need to loosen the rocker-shaft support pedestal nuts or bolts gradually in sequence, then remove them. Lift off the rocker shaft and put it on clean newspaper.
On engines with separately mounted rocker arms, take off the nuts holding the arms and the pivot balls, then remove the arms and set them all in a row on a piece of paper numbered with their correct order, so you can refit them in the same places.oil seals..
Lift out the pushrods and stick them through numbered holes in a piece of cardboard or plastic foam; they too must go back in the same places. Keep them in a clean place.
Use a socket and bar to loosen the nuts or bolts securing the head in the reverse of the tightening sequence for the engine (see car handbook). Some engines need a special adaptor tool to fit the bolts. cap seal.
Carefully lift off the head, complete with manifolds if possible. You may need a helper to lift the head. If it sticks, tap the side gently with a soft-faced hammer.
Set the head right way up on wood blocks to protect its machined undersurface. Remove and discard the head gasket, after checking that the replacement one is the same in every detail.
Take care not to let any dirt or carbon particles fall into the engine while you are working on it.oil seals..
No comments:
Post a Comment