cap auto oil seals skillful manufacture

Removing the inlet-manifold gasket cap auto oil seals skillful manufacture
Remove the air cleaner. Make a careful note of all the connections to the carburettor.
Disconnect the choke and throttle cables to the carburettor. Then take off the fuel pipe.
If possible, keep the disconnected end of the fuel pipe higher than the level of fuel in the fuel tank.ring oil seals.
If the end of the pipe is lower than the fuel level, plug it with a pencil stub or a small bung.
If the carburettor has an automatic choke, disconnect the water pipes or wires at the choke.
The inlet manifold may be on one side of the engine and the exhaust on the other, as shown here.cap auto oil seals skillful manufacture.
The inlet manifold may be on one side of the engine and the exhaust on the other, as shown here.
You may have to remove the carburettor completely (See Removing a carburettor for cleaning) before you can remove the manifold. If so store it upright in a clean place.auto oil seals.
Take care not to damage the carburettor mounting block, which may be made of rubber or a composition material, and acts as a gasket.auto oil seals.
If the intake manifold is water-heated, drain the car cooling system (See Checking and topping up car antifreeze coolant) until the coolant level is lower than that of the inlet manifold.nok oil seals.
Disconnect the pipes or hoses from the intake manifold. Disconnect the brake servo pipe if fitted.
Remove the manifold and replace the gasket.
If the manifold is water-heated, and particularly if it is on a V-engine, check with your local dealer or with a service manual to see whether gasket sealant should be used on both sides of the gasket.
Reassembly is the reverse order of removal. When reassembly is complete, top up the car cooling system, viton oil seals,run the engine up to working temperature and check that there are no leaks.cap auto oil seals skillful manufacture.