A leak may be caused by a loose clip, or by
the gaiter being misplaced under a clip.auto oil seals. The rubber itself may be damaged, so
always check the whole gaiter thoroughly along its length.Depending on the
layout of your car, you may need to raise the car on axle stands or even remove
the front wheels to inspect the gaiters. fkm auto oil seals skillful manufacture.Use a
small mirror and a torch or inspection lamp to help you to inspect parts that
are awkward to see.mechanical oil seals.
You can make a temporary repair to a holed gaiter by tying a plastic bag over it.Do not turn the steering wheel rapidly when the car is not standing on its wheels. The resulting surge of pressure can burst the gaiters.Clean the gaiters thoroughly (use a proprietary degreaser if necessary – not paraffin or petrol, which may damage the rubber). Any oily or greasy patch caked with dirt could mean a crack – so check thoroughly.valve oil seals.
Make sure a gaiter is not twisted. Get a helper to turn the steering slowly so that you can see whether any are twisted.Relieve any twist by loosening the inner gaiter clip, straightening the gaiter and refastening the clip. If it was a wire clip, replace it with a new screw clip.Do not alter the placing of the outer end of the gaiter, which must be exact to prevent overstretching.fkm auto oil seals skillful manufacture.
Examine the clips to make sure they are tight (but not so tight as to cut into the rubber). Make sure also that they are in the right place and not badly corroded. Rusty clips should be replaced.Look over the whole gaiter carefully for cracking and chafing. Cracks are most likely at the crests and troughs of the ridges, and at the ends.auto oil seals.Squeeze the gaiter with your fingers. Then have a helper turn the steering slowly while you watch for cracks opening up.viton oil seals.
Even the smallest crack may let grit in as well as letting oil out. As a temporary measure, tie a plastic bag firmly over the gaiter while it is extended.As soon as possible, replace the gaiter and thoroughly inspect the inner track-rod ball joint.fkm auto oil seals skillful manufacture.
You can make a temporary repair to a holed gaiter by tying a plastic bag over it.Do not turn the steering wheel rapidly when the car is not standing on its wheels. The resulting surge of pressure can burst the gaiters.Clean the gaiters thoroughly (use a proprietary degreaser if necessary – not paraffin or petrol, which may damage the rubber). Any oily or greasy patch caked with dirt could mean a crack – so check thoroughly.valve oil seals.
Make sure a gaiter is not twisted. Get a helper to turn the steering slowly so that you can see whether any are twisted.Relieve any twist by loosening the inner gaiter clip, straightening the gaiter and refastening the clip. If it was a wire clip, replace it with a new screw clip.Do not alter the placing of the outer end of the gaiter, which must be exact to prevent overstretching.fkm auto oil seals skillful manufacture.
Examine the clips to make sure they are tight (but not so tight as to cut into the rubber). Make sure also that they are in the right place and not badly corroded. Rusty clips should be replaced.Look over the whole gaiter carefully for cracking and chafing. Cracks are most likely at the crests and troughs of the ridges, and at the ends.auto oil seals.Squeeze the gaiter with your fingers. Then have a helper turn the steering slowly while you watch for cracks opening up.viton oil seals.
Even the smallest crack may let grit in as well as letting oil out. As a temporary measure, tie a plastic bag firmly over the gaiter while it is extended.As soon as possible, replace the gaiter and thoroughly inspect the inner track-rod ball joint.fkm auto oil seals skillful manufacture.
No comments:
Post a Comment