Check the engine oil level weekly more often if the engine
is consuming some oil, and always before a long drive. Change the oil and renew
the oil filter at recommended service intervals.auto rubber oil seals cleaning.
The front or rear of the car, depending on engine layout, will usually have to be raised – either on ramps, or jacked up and supported on axle stands – to give working room under the engine.silicon seal.
The old oil should be drained with the engine warm, so that it flows more freely, taking with it any harmful deposits. Run the engine for a few minutes, then switch off and put a drain can or container big enough to hold all the engine oil under the sump drain plug.auto rubber oil seals cleaning.
How to drain engine oil and remove filter.viton seal.
Clean the plug with a clean rag and slacken it, using either a universal drain-plug key or a suitable ring spanner or socket, depending on the type of plug fitted.
Unscrew the plug, remove it by hand and let the oil flow into the can. Remember that the oil may be very hot, so avoid contact with it.bearing seal.
Wait until no more oil drips from the drain hole, then clean the drain-hole threads and the surrounding area with a clean cloth or tissue.
Clean the drain plug too, and make sure its washer or gasket is in good condition. Replace it if it is worn or broken. Refit the plug but do not overtighten it.auto rubber oil seals cleaning.
The front or rear of the car, depending on engine layout, will usually have to be raised – either on ramps, or jacked up and supported on axle stands – to give working room under the engine.silicon seal.
The old oil should be drained with the engine warm, so that it flows more freely, taking with it any harmful deposits. Run the engine for a few minutes, then switch off and put a drain can or container big enough to hold all the engine oil under the sump drain plug.auto rubber oil seals cleaning.
How to drain engine oil and remove filter.viton seal.
Clean the plug with a clean rag and slacken it, using either a universal drain-plug key or a suitable ring spanner or socket, depending on the type of plug fitted.
Unscrew the plug, remove it by hand and let the oil flow into the can. Remember that the oil may be very hot, so avoid contact with it.bearing seal.
Wait until no more oil drips from the drain hole, then clean the drain-hole threads and the surrounding area with a clean cloth or tissue.
Clean the drain plug too, and make sure its washer or gasket is in good condition. Replace it if it is worn or broken. Refit the plug but do not overtighten it.auto rubber oil seals cleaning.
No comments:
Post a Comment